Skip to content

Sensors and readings

Ways to see the climate somewhere without standing there: signs that measure their own spot, and remote sensors that report to a sensor hub.

Every reading is taken the same way as /hvac temperature at that spot. A spot deep in a system's airflow reads the room, one near the edge a blend, and one outside every system the outdoors.

Thermometers, hygrometers, thermo-hygrometers and air monitors

Look at a sign and run one of:

/hvac create thermometer [label]
/hvac create hygrometer [label]
/hvac create thermohygrometer [label]      ("thermohygro" works too)
/hvac create airmonitor [label]
Thermometer         Hygrometer          T. Hygrometer
Thermometer         Hygrometer          In 72.1 F 58%
Inside: 72.4 F      Inside: 58%         Feels 73.0 F
Outside: 64.0 F     Outside: 41%        Out 64.0 F 41%
  • Thermometer: the temperature where the sign is, and outdoors.
  • Hygrometer: the humidity where the sign is, and outdoors.
  • Thermo-hygrometer: temperature, humidity and "feels like" together.
  • Air monitor (3.2): the Air Quality Index, coloured by its band, with what drives it when it isn't Good (AQI 88 Smoke), and the pollen. See Air quality.

They belong to no system and can go anywhere, outdoors too. Breaking the sign removes them.

Sensors and sensor hubs

A sensor hub is a sign that shows up to nine sensors, three to a page. A sensor is a button, and the button decides what it measures:

Button Measures
Stone button Temperature
Polished blackstone button Humidity
Mangrove button Temperature and humidity
Birch button Weather: Clear, Rain, Thunder or Snow
Cherry button Air quality: the AQI (3.2)
Bamboo button Wind: Gale 61km/h (3.2)
/hvac create sensor [label]        look at the button
/hvac create sensor-hub [label]    look at a sign ("sensorhub" works too)
/hvac link-tool                    gives the link tool ("sensor-tool" works too)

With the link tool:

  1. Right-click a sensor hub to select it.
  2. Right-click sensors to link them: at most nine, in the same world.
  3. Sneak-right-click a sensor to unlink it.

One sensor can be on several hubs.

Using a hub

Home 1/3
Kitchen 72F 45%
Cellar 58%
Garden Rain
  • Right-click the hub to turn the page.
  • Sneak-right-click it to switch auto-flip on or off: it turns the page every 5 seconds and remembers that across restarts.
  • Right-click a sensor to see its full reading in chat. Sensors never send a redstone signal, even when an arrow hits a wooden one.
  • A sensor in an unloaded chunk shows --.
  • /hvac info on a hub lists every sensor with its reading.

Weather sensors

A birch button works like a rain gauge: it needs open sky above it. Under a roof, glass or leaves it shows Covered. Where weather never reaches, such as a desert, it shows Clear. It reports the sky even if EZvac's weather effects are switched off.

Removing

Breaking a sensor, or the block it hangs on, takes it off every hub. Breaking a hub's sign removes the hub. /hvac remove works on both.

Good to know

  • Readings vary a little from spot to spot, the way a real house does; see Climate.
  • Signs update only near players; see Equipment.
  • Reading and paging need ezvac.use; creating and linking need ezvac.admin.